Link Shock Mounts – Flat Top
$275.00
Flat-top link shock mounts for building a linked truck bed cage. Works with a single coil-over or combined bypass shock setup. Sits 4.25″ further forward than the dome-top version for different fitment requirements.
Flat Top: The Further-Out Shock Position
The flat-top link shock mounts position the shock tube 4.25\” further outboard than the dome-top version. That extra distance is the right call when your bed cage geometry benefits from a wider shock placement — common in longer-wheelbase trucks, builds using larger bypass shocks, or setups where the coilover needs to be angled outward for clearance reasons.
What Is Included
- Flat-top link shock mounts (pair)
Dome Top vs Flat Top — The Short Version
Dome top: shock sits 4.25\” closer to the truck. Flat top: shock sits 4.25\” further out. Choose based on your specific shock body, bed length, and cab clearance. If you are building both a coilover and a bypass shock into the same cage, flat top often works better because the wider position gives the bypass shock room to run alongside the coilover without fighting for space. Unsure? Call 714-265-1450 and we will sort it out for your specific build.
Shock Compatibility
Works with a single coil-over or combined coil-over and bypass shock setup. Pairs with Link Killer Shocks and Solid Shock Co. coil-overs. See those listings for shock sizing and pricing.
Installation Notes
Weld-on. Shock angle is determined by mount position — measure your shock stroke and axle travel range before finalizing position. Still requires careful positioning before final weld despite the more forgiving outboard placement.
Related products
-
WIY Shackles – Toyota, S-10, Nissan, Explorer
$195.00Add to cartWeld-it-yourself shackle kit for mounting 62″ or pre-runner springs on Toyota, S-10, Nissan, Explorer, and more. Makes a pair of 12″ shackles with all frame mount hardware — at half the cost of the bolt-on version.
-
Axle Truss – Weld It Yourself
$550.00Select options This product has multiple variants. The options may be chosen on the product pageWeld-it-yourself axle truss to prevent axle bending and center section separation. No axle preload required before welding. Fits most common rear axles — Dana 35, Dana 44, Dana 60, Ford 8.8, GM 11.5, Sterling, and more.
-
Weld It Yourself 4-Link Frame Pivots
$350.00Add to cartWeld-it-yourself bolt-on frame pivots for 3 or 4-link builds on open C-channel frames. Budget entry point for linking your truck with a single coil-over or bypass shock setup.
-
Upper 4-Link Tabs – Ford 9″
$175.00Add to cartWeld-on upper 4-link tabs for Ford 9″ rear axles. Available in centered (63.5″ to WMS) or offset (66″ or 69″ to WMS) housing configurations. Perfect starting point for custom upper link arm placement.