Upper 4-Link Tabs – Ford 9″
$175.00
Weld-on upper 4-link tabs for Ford 9″ rear axles. Available in centered (63.5″ to WMS) or offset (66″ or 69″ to WMS) housing configurations. Perfect starting point for custom upper link arm placement.
Upper Link Tabs — Built for the Ford 9\”
The Upper 4-Link Tabs for Ford 9\” axles are the axle-side mount for the upper link arm in a 4-link suspension build. Available in two housing configurations — centered (63.5\” to wheel mounting surface) and offset (66\” or 69\” to WMS) — to match the specific Ford 9\” housing width you are running.
Upper link placement is one of the most consequential geometry decisions in a 4-link build. The height of the upper link mount relative to the lower determines your instant center, which drives anti-squat characteristics, driveshaft angle under load, and suspension behavior under acceleration and braking.
What Is Included
- Upper 4-link tabs (pair)
Centered vs Offset — Which Do You Need?
- Centered (63.5\” to WMS): Housing centered under the truck. Standard for most production axles and stock-width builds.
- Offset (66\” or 69\” to WMS): Housing offset — common when a narrowed or widened 9\” is used, or when chassis width dictates an offset housing for correct track width.
Measure from the WMS on each side of your axle. If they are equal, you are centered. If not, you are offset. Call 714-265-1450 to confirm before ordering.
Pairs With
Lower 4-Link Tabs, 4-Link Frame Pivots (Boxed or Open C-Channel), Link Shock Mounts, and Link Arms. For a complete axle-side solution, see the Upper and Lower 4-Link Tabs combo set.
Related products
-
WIY Front Bumper – F-150 / F-250 / Bronco
$450.00Add to cartWeld-it-yourself front bumper kit for 92–96 Ford F-150, F-250, and Bronco. Main mount welds to the inside of the frame for earlier model fitment. Simple construction yields a strong, custom look at a DIY price.
-
Link Shock Mounts – Dome Top
$275.00Add to cartDome-top link shock mounts — the starting point for building a linked truck bed cage. Compatible with a single coil-over or combined bypass shock setup. Sits 4.25″ less forward than the flat-top version.
-
Link Shock Mounts – Flat Top
$275.00Add to cartFlat-top link shock mounts for building a linked truck bed cage. Works with a single coil-over or combined bypass shock setup. Sits 4.25″ further forward than the dome-top version for different fitment requirements.
-
Weld It Yourself 2WD Equal Length I-Beam Plate Kit
$450.00Add to cartWeld-it-yourself equal-length I-beam plate kit for custom 2WD long-travel front suspension. Includes main beam plates, end caps, teardrop plates, back layer plates, front overlay, and threaded bungs. Tubing, heims, and welding required.